← All articles · Leer en español
Everyday health · 2 min
Preparation helps monitors show true numbers
Rest and correct arm position help your monitor show the right number.
Reviewed by Velantri physicians on November 22, 2026
Why preparation matters
Blood pressure changes throughout the day. Many things affect the reading. Smoking raises blood pressure for a short time. Caffeine also raises it. Exercise makes the heart pump harder. Even a full bladder can change the number. When someone skips these steps, the monitor may show a number that is higher than usual. That can be confusing. Proper preparation helps the monitor capture a typical reading. The goal is to see what the pressure is during a calm, rested state. This rested state reflects how the body works most of the time. A single high reading does not mean someone needs a change in care. Patterns over many days give a clearer picture.
What to do before measuring
Avoid smoking for thirty minutes before measuring. Skip caffeine for thirty minutes too. Do not exercise for thirty minutes beforehand. Empty the bladder before sitting down. Then rest quietly for at least five minutes. Sit still during this rest time. Do not talk or look at a phone. This rest lets the body settle. The heart rate slows to its normal pace. Find a quiet room where no one will interrupt. Sit in a comfortable chair with a back. Put both feet flat on the floor. Let the shoulders relax. Take a few slow breaths. This quiet time is just as important as the measurement itself.
How to position the arm
Use a bare arm without clothing over it. Support the arm at heart level. The cuff must be the correct size for the arm. A cuff that is too small gives a number that is too high. A cuff that is too large gives a number that is too low. The arm should rest on a table or chair arm. Keep the arm still during the measurement. Do not hold the arm up in the air. The middle of the cuff should line up with the heart. If the arm hangs down, the reading will be higher than it should be. If the arm is held too high, the reading will be lower. Getting the position right takes a little practice.
Recording the results
Measure at least two times with one minute between readings. Use the same validated monitor each time. Write down both numbers with the date and time. Some people like to use a notebook. Others use a simple chart. Record the numbers even if they seem unusual. Bring the monitor and the written record to clinic visits. The doctor can check that the monitor works correctly. The recorded numbers help the doctor see patterns over time. A pattern is more useful than any single reading. Looking at many measurements together shows whether pressure stays steady or changes. This information helps a care team make the best plan.
Try this
Before the next measurement, set a timer for five minutes and rest quietly in a chair with both feet flat on the floor and the arm supported at heart level.
Quick check
What should someone do in the thirty minutes before measuring blood pressure?
Answer: Avoid smoking, caffeine, and exercise — Smoking, caffeine, and exercise can all raise blood pressure temporarily, so avoiding them for thirty minutes helps the monitor show a typical reading.
How should the arm be positioned during a measurement?
Answer: Bare and supported at heart level — A bare arm supported at heart level with the correct cuff size gives the most accurate reading.
How many readings should be recorded at home?
Answer: At least two readings one minute apart — Recording at least two readings one minute apart with the same monitor helps capture a reliable result.
Sources
This article is general health education reviewed by physicians. It is not medical advice for your situation. Talk to your clinician before changing medication or treatment, and seek urgent care for symptoms that worry you.